Pennock's Fiero Forum
  Technical Discussion & Questions
  Tranny Advice

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
Tranny Advice by edfiero
Started on: 09-14-2014 05:58 AM
Replies: 1 (105 views)
Last post by: edfiero on 09-23-2014 12:05 PM
edfiero
Member
Posts: 880
From: Coatesville, PA
Registered: Nov 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post09-14-2014 05:58 AM Click Here to See the Profile for edfieroClick Here to Email edfieroSend a Private Message to edfieroEdit/Delete MessageReply w/QuoteDirect Link to This Post
I'm picking up a 4 speed manual out of a 85 V6.
When I swap it in, I'll be putting a new clutch disk, pressure plate and throw out bearing while its a part and replacing the shaft seals.
What else should I change out, or at least inspect, so I don't have to do this job again? And for those things which I am inspecting, what should I be looking for?
Thanks
IP: Logged
PFF
System Bot
edfiero
Member
Posts: 880
From: Coatesville, PA
Registered: Nov 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post09-23-2014 12:05 PM Click Here to See the Profile for edfieroClick Here to Email edfieroSend a Private Message to edfieroEdit/Delete MessageReply w/QuoteDirect Link to This Post
Bump.
I got the tranny and opened the case. Its clean inside, and no stripped out gears. What else do I check?
How do I confirm the bearings are good?
IP: Logged

next newest topic | next oldest topic

All times are ET (US)

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock