Pennock's Fiero Forum
  Technical Discussion & Questions
  Custom CV shaft

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


 next newest topic | next oldest topic
Custom CV shaft by Lurate
Started on: 04-07-2014 12:15 PM
Replies: 1 (99 views)
Last post by: darkhorizon on 04-07-2014 12:18 PM
Lurate
Member
Posts: 133
From: Pensacola, FL USA
Registered: Apr 2006

Feedback score: N/A
Leave feedback

Rate this member
Report this Post04-07-2014 12:15 PM Click Here to See the Profile for LurateClick Here to visit Lurate's HomePageSend a Private Message to LurateEdit/Delete MessageReply w/QuoteDirect Link to This Post
I need help finding someone that can make a custom CV shaft for my 3800 engine swap into a custom wide track suspension (355 kit car). Any help would be greatly appreciated. It is an automatic transmission
IP: Logged
PFF
System Bot
darkhorizon
Member
Posts: 12279
From: Flint Michigan
Registered: Jan 2006

Feedback score: (1)
Leave feedback





Total ratings: 451
Rate this member
Report this Post04-07-2014 12:18 PM Click Here to See the Profile for darkhorizonSend a Private Message to darkhorizonEdit/Delete MessageReply w/QuoteDirect Link to This Post
You shouldnt need to go custom. There are plenty of axles 2-4 inches longer than typical 4t65e swap axles. Measure what you need, and go to the junkyard and get them.
IP: Logged

next newest topic | next oldest topic

All times are ET (US)

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock