Pennock's Fiero Forum
  Technical Discussion & Questions
  Aligning Thrust Bearing

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
Aligning Thrust Bearing by smmilke
Started on: 12-03-2013 07:35 PM
Replies: 1 (67 views)
Last post by: Gall757 on 12-03-2013 08:22 PM
smmilke
Member
Posts: 128
From: Fairbanks, Alaska
Registered: May 2012


Feedback score: (1)
Leave feedback

Rate this member

Report this Post12-03-2013 07:35 PM Click Here to See the Profile for smmilkeSend a Private Message to smmilkeEdit/Delete MessageReply w/QuoteDirect Link to This Post
Putting new main bearings in my 2.5 and I'm not sure how to align the thrust bearing. Couldn't find a description of the process in the service manual so I was hoping someone here could lay it out for me. Any tips on getting the thrust bearing cap separated from the block would be nice too!
IP: Logged
PFF
System Bot
Gall757
Member
Posts: 10938
From: Holland, MI
Registered: Jun 2010


Feedback score: N/A
Leave feedback





Total ratings: 90
Rate this member

Report this Post12-03-2013 08:22 PM Click Here to See the Profile for Gall757Send a Private Message to Gall757Edit/Delete MessageReply w/QuoteDirect Link to This Post
IP: Logged

next newest topic | next oldest topic

All times are ET (US)

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock