Pennock's Fiero Forum
  Technical Discussion & Questions
  4.9 ECM reading low voltage. On what Pin ?

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


 next newest topic | next oldest topic
4.9 ECM reading low voltage. On what Pin ? by falcon_ca
Started on: 08-07-2013 09:18 PM
Replies: 1 (133 views)
Last post by: phonedawgz on 08-08-2013 03:46 AM
falcon_ca
Member
Posts: 1291
From: Chicoutimi, Quebec, Canada
Registered: Dec 2007

Feedback score:    (26)
Leave feedback

Rate this member
Report this Post08-07-2013 09:18 PM Click Here to See the Profile for falcon_caSend a Private Message to falcon_caEdit/Delete MessageReply w/QuoteDirect Link to This Post
I need to know what is the pin used by 4.9 ECM gets the voltage information, because according to TunerPro, it see 11.2 Volts while my Multimeter reads 13.4 or higher.

There is probably something wrong with that wire/pin.

------------------
"I'm not driving too fast, . . . I'm just flying too low."

Work done 07-08 | Work done 08-09 | Work done 09-10 | Work done 10-11 | Work done 11-12 | Work done 12-13 |Work done 13-14 | 4.9 Swap |Parts for sale

IP: Logged
PFF
System Bot
phonedawgz
Member
Posts: 17091
From: Green Bay, WI USA
Registered: Dec 2009

Feedback score:    (23)
Leave feedback





Total ratings: 290
Rate this member
Report this Post08-08-2013 03:46 AM Click Here to See the Profile for phonedawgzClick Here to visit phonedawgz's HomePageSend a Private Message to phonedawgzEdit/Delete MessageReply w/QuoteDirect Link to This Post
E13 - Gray - Fuel Pump Voltage Feedback
IP: Logged

next newest topic | next oldest topic

All times are ET (US)

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock