Pennock's Fiero Forum
  Technical Discussion & Questions
  2.8 to 3400 harmonic balancer timing markings

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
2.8 to 3400 harmonic balancer timing markings by potopaj
Started on: 08-06-2013 11:48 AM
Replies: 1 (186 views)
Last post by: trotterlg on 08-06-2013 12:50 PM
potopaj
Junior Member
Posts: 2
From: chisago city, mn, usa
Registered: Jan 2011


Feedback score: N/A
Leave feedback

Rate this member

Report this Post08-06-2013 11:48 AM Click Here to See the Profile for potopajClick Here to Email potopajSend a Private Message to potopajEdit/Delete MessageReply w/QuoteDirect Link to This Post
Hey guys. I searched trying to find my answer on where to mark the new location on the 2.8 harmonic balancer when switching it to the 3400 block (out of a venture). All the results were along the lines of "match up the 2.8, and 3.4 balancer, mark, score, done" That is awesome if you have both, but my 3400 came without a balancer. does anyone know exactly where to cut (something like 124mm counter clockwise of the existing timing mark) would be the cat's meow.

Thanks fellow Fiero guys.
IP: Logged
PFF
System Bot
trotterlg
Member
Posts: 1378
From: WA
Registered: Aug 2011


Feedback score: (2)
Leave feedback

Rate this member

Report this Post08-06-2013 12:50 PM Click Here to See the Profile for trotterlgClick Here to Email trotterlgSend a Private Message to trotterlgEdit/Delete MessageReply w/QuoteDirect Link to This Post
I bolted on the balancer, put a stick in the spark plug hole of #1 cylinder, turned the engine to TDC and marked the balancer. Larry
IP: Logged

next newest topic | next oldest topic

All times are ET (US)

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock