Pennock's Fiero Forum
  Technical Discussion & Questions
  F23 Throw out fingers stock height?

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
F23 Throw out fingers stock height? by phonedawgz
Started on: 08-01-2014 02:33 PM
Replies: 0 (51 views)
Last post by: phonedawgz on 08-01-2014 02:33 PM
phonedawgz
Member
Posts: 17011
From: Green Bay, WI USA
Registered: Dec 2009


Feedback score:    (23)
Leave feedback





Total ratings: 290
Rate this member

Report this Post08-01-2014 02:33 PM Click Here to See the Profile for phonedawgzClick Here to visit phonedawgz's HomePageClick Here to Email phonedawgzSend a Private Message to phonedawgzEdit/Delete MessageReply w/QuoteDirect Link to This Post
Anybody have the stock height of the throw out fingers as measured from the crank flange for a F23 2.2?

How about the stock height of the crank flange vs the bellhousing?

Is it that we are effectively moving the flywheel surface towards the bellhousing about 0.250"?
IP: Logged
PFF
System Bot



All times are ET (US)
next newest topic | next oldest topic

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock