Has any one installed C6 Corvette seats in their Fiero?
From the measurements I took they look like they should fit.

Not C6, but C5 seats fit easy, stock fiero rails, only had to drill 4 holes, two in the seat bottom, two on the rails. They do fit a little to the inside than stock and I had to put a few washers between the seat and rail to make room for the adjuster lever. Very happy with the fit.



Rob

[This message has been edited by qwikgta (edited 12-28-2017).]

Not a lot of help but I have a set of C4 seats in one of my Meras. If the dimensions are similar, it certainly might be possible.

Nelson

I'm no help, but I think the seat architecture changed with the C7. Those seats DO NOT fit. I believe the previous years are pretty close to each other.

Bob

------------------

My Build

[This message has been edited by RCR (edited 12-28-2017).]