Wondered why my door trim didn't quite fit right. No idea what this is supposed to be for but it's not for a Fiero. Stole one from the Formula. I'll install it Friday.

Knew there was an issue when I saw this.



Hmm....this would explain things.

Zip ties, rubber bands, and why are those silver screws on the power lock switch? IIRC, that switch snaps into place. It's a pain to get out. I'm always afraid something will break. I don't recall electrical tape on the wiring there, either, but could be mistaken. Was this a conversion to power windows?

[This message has been edited by tshark (edited 04-28-2015).]

The zip ties are/were holding the rear of the door handle trim in place (since there's no place for the hidden screw to screw into). I don't see any rubber bands but then again, I just noticed the screws holding the p/lock buttons in place. I doubt it was a conversion as the other side looks normal (no tape, no screws).