I am selling my 3800 Swap harness because my setup changed and now I no longer need this harness. This wiring harness was the last harness that PBJ did back in 2007. Pete checked every connection before sending it out to me and he sold many 3800 swap harnesses without a single problem with any of them. This specific harness was wired to work with any 98-02 L67 in a fiero with a getrag manual transmission. The c500 is wired in the stock location and the PCM was setup to be between the seats like factory. This harness uses the 88 fiero oil pressure sending unit, the 3 wire coolant temp sender, wiring harness is setup to work with a/c, EGR deleted, 3800 alternator in the low mount position. The OBD2 connector is extra long so you can put in up under the dash like the newer cars. The harness is partially loomed, the injector harness is finished with heat shrink tubing on it so that the wiring on the injectors is very neat and you can hide it next to the fuel rail. This harness needs nothing done to it. Just plug it into your engine and transmission. Asking 400.00 shipped for it. Thanks Daniel
