Fall cleaning of some cupbords in my shop revealed a few dozen items that are too good to discard, but I probably wouldn't use any of them in my lifetime.
All prices listed include shipping to lower 48.Rodney Dickman 3.4 starter jig. Used once by me. $30.00
SOLD
Rodney Dickman output shaft seal for his Getrag bearing saver kit. $12.50
Dark grey (87/88) auxilliary guage surround. No warpage or scuffs. $25.00
SOLD
Instrument cluster trim pieces. 1. charcoal, 2. bronze. 3. dot matrix. $15.00 each
DOT MATRIX SOLD
New Stant locking cap with set of keys. $12.50
New std main and rod bearings for 2.8 V6. $25.00 each or $40.00 for both
Felpro 2.8 gasket set. some pieces missing, so look at the picture carefully.
The head gaskets are for a 3.4 $25.00 for everything you see here
SOLD
NOS AC compressor lead. $12.50
SOLD
NOS felt window guides. $12.50
SOLD
Really nice black Camaro/Firebird AT shift knob. $12.50
SOLD
Trunk latch assy. $12.50
SOLD
Dr side areo ground fx door molding. Super straight with no broken tabs. $25.00
Locking lug nuts with tool. $15.00
Dot matrix HVAC trim bezel. cracks at bottom that were super glued back in place and a nick on the top corner. Definitely daily driver stuff. $15.00
Nice ash tray doors and springs.(no picture available) $15.00
[This message has been edited by rpro (edited 10-04-2012).]
