Someone left my 4.9 out in the rain... long story short, I need someone to make me a new T-stat filler housing...
I borrowed these images...
Originally posted by twofatguys:
I would like for it to be long enough that I can use the Fiero t-stat, so that I can burp it more easily and not have to wait for all the little bubbles to work their way through the little 1/8" hole.
originally posted by falcon_ca
And I would like it clocked about 30 degrees towards the distributor such that I can get the bolts in and out easier, like this one.
I can send you the parts or you can source them locally, either way, what I really need is someone that can weld to do this for me. Let me know your price.
Im emailing a guy about buying mine... Im only wanting $675-700 for mine.. I will let you know. Um teally needing the $ in the next few days, or I might keep it...
------------------ aka. SmoothGT NotAFieroAnyLonger CURRENT BUILD: " SmoothGT-'w8nc' "
Im emailing a guy about buying mine... Im only wanting $675-700 for mine.. I will let you know. Um teally needing the $ in the next few days, or I might keep it...
Got any pictures of the car you can send me? Where is it located and what is the run down on it.....
IP: Logged
05:47 PM
jscott1 Member
Posts: 21676 From: Houston, TX , USA Registered: Dec 2001
This is very simple to make. I recomend you take a neck you have and cut it/clock it into position. Take it to a muffler shop with a $20 bill an walk into the back shop (not the front counter) and ask someone to weld it for you. 10 minute job.
Aaron
IP: Logged
08:54 PM
jscott1 Member
Posts: 21676 From: Houston, TX , USA Registered: Dec 2001
