=== Edit ===
Sold to Steel
==========
Due to a freak hail storm damaging both of my daily drivers I need to shed some parts, so...

I have a 3800sc harness and programmed PCM from FIEROFLYER. The harness is setup for a 3800sc Series 2 motor with 4T65E-HD transmission and NorthStar throttle body. The PCM comes with it and was programmed by FIEROFLYER as well. I'll try to get some pictures this afternoon.

$500 shipped to the lower 48, ask about anywhere else.

------------------
-Brian

My 87 GT Poly Suspension Upgrade (all pics) thread
Removing the roof panel

[This message has been edited by MulletproofMonk (edited 05-28-2011).]

What year Fieros does it work with?

quote Originally posted by Steel: What year Fieros does it work with?

Mine is an 87GT, but it should work with all 85-88 Fieros. The 84 has the C500 in a different location so this harness won't match up.

PCM mount in the stock location behind console?
Is there AC wired in? If so GP or Fiero style compressor?
EGR/evap?
What alternator is it wired for?

Also was the harness ever installed/used after FieroFlyer wired it? Just curious.

Thanks.

[This message has been edited by Steel (edited 05-28-2011).]

quote Originally posted by Steel: PCM mount in the stock location behind console? Is there AC wired in? If so GP or Fiero style compressor? EGR/evap? What alternator is it wired for? Also was the harness ever installed/used after FieroFlyer wired it? Just curious.

The PCM mounts in the stock Fiero ECM location.
Yes the AC is wired. I believe that the AC connector is the same, it does plug into my GP compressor. Since I don't have a stock motor to test that theory...
EGR yes, EVAP no.
Wired for 3800 Alternator and is long enough for a low mount.
No the harness wasn't used yet.

It isn't that I didn't want to use it, I am so close. Luck is against me and the deductible on each of my cars is $500 and $1,000 on my house...

Thanks for the pictures. Very bad luck with the hail man that sucks..

I'll take the harness/pcm it's very close to what I need.

[This message has been edited by Steel (edited 05-28-2011).]

quote Originally posted by Steel: Thanks for the pictures. Very bad luck with the hail man that sucks.. I'll take the harness/pcm it's very close to what I need.

What do you need to modify? Back to stock throttle body or are you adding the EVAP? Let me know in a PM and I will see if I have the right plugs to throw in the box with the harness and PCM.
PM sent with paypal address.

Pm sent as well as payment~