Well like many others financial reasons are making me give up my project car.
It is a V6 4spd 85 notchie currently fully dismantled / cleaned and was in progress of doing frame repair / repaint.


Notable items:
I have the title for the car (will go with the frame unless someone makes me a really good offer otherwise)
haynes service manual (standard fleet farm fare)


Just post what your looking for (I can post new pictures if requested)
I am willing to box and ship anything that will fit USPS or UPS. Larger freight items I may be able to pack but pickup would be needed. (Post and I will see what I can do)

I am taking best offer as long as they are reasonable (ie greater than scrap value) + shipping.

Well down to the end of the list. Selling by the pound (Seriously. Once I finish sorting the garage making a run to the scrap yard)

[This message has been edited by Wire (edited 05-15-2010).]

There are some minor odds and ends that are not on this list. Mostly hindges / latches / cables if your looking for something just drop me a PM


Windshield wiper motor and control arms
Clutch arm
Dog bone cover
rim centers [SOLD]
Parking break lever assembly
Gas peddle assembly [SOLD]
Radio antenna cable and base


Seat belts (mounting hardware as well not shown)
Sun roof latch [SOLD]
Front hood release assembly
Gas cap release assembly

Radiator fan (works)


AC core [SOLD]
2 relays (mount on rear of the HVAC box
Fan speed resistors (tested good)
HVAC flapper motors (Will test)
Heater core
HVAC fan and motor
Power window buttons [SOLD]
Map sensor
engine relay
Vacuum valve assm
Tach filter cap


Wheel well screws and push rivets
Under dash clips and push rivet things
Hood switch
Break booster / master cylinder mounting hardware and spring


Random dash plastic parts
Overhead map lights with trim and wiring
Rear view mirror with mounting block
Gas cap door and mounting hardware


Steering wheel [SOLD]
steering wheel center "spider" + trim (leather wrapped part sill available) [SOLD]
Headlight high beam switch
Ignition switch
Turn signal stock with curse control


Various engine sensors (will check if your interested)
spark plug cable brackets [SOLD]


AC compressor [SOLD],
Collector,
High pressure switch



E-break cables (3 pcs)
Front hood pop cable
Accelerator cable (V6)
Cruse control to throttle body cable (V6)



Gas lines
Front break balancing block with switch + break line (dup of above image moved it to the right box)
Cold start injector and tube [SOLD]
Oil pressure remote mount tube


Various relays / modules / switches (box one of 2) top left to to bottom right
intermittent wipers (I think)
seat belt dinger
Break light switch
Cruse control switches (x2)
shifter interlock switch (with clip)
Engine compartment relays
blinkers (x2)
headlight harness relay
headlight issolation relay [this one is sold. Have 2 more]
power lock relay [SOLD]
under dash relay
under dash relay
Dimmer module
30A circuit breakers




Full dash cluster
Insturment cluster + clear lens [SOLD]
brushed metal over lay [SOLD]
Headlight / dimmer switch assm
Trunk release assm
Full set of trim and support structure. (all in good shape with no delamination so far.
will break down and sell as parts (easier and safer to store this way)



Radio [SOLD]
HVAC controls (car had AC)
aftermarket speaker (fit standard dash mounting) no rips or tears in the cones
very nice speaker grills. Fabric is tight and in great shape. No broken pins on the back [SOLD]


Set of 4 seat speakers. Cones look to be in good shape with no tears.


[Forgot to take a picture of the inside but similar shape to passenger door]
Outside of driver side door (I found the missing trim piece but clips are busted on door) [SOLD]
Ground effect trim [SOLD]
Ribbed trim [SOLD]
Glass is present and unbroken but has some scratches. [SOLD]
Outer dew wipe is cracking up. Inner is in good shape and still pliable
Power lock motor + hardware
Power window motor [SOLD]
Door latch asm + strike [SOLD]



Outside of passenger side door [SOLD]
Ground effect trim [SOLD]
Ribbed trim [SOLD]
Glass is present and unbroken. Have not rolled up the window to look at in 4 years. If your interested let me know and I can go pull it out. [SOLD]
Outer dew wipe is cracking up. Inner is in good shape and still pliable
Power locks and windows
Door latch asm + strike [SOLD]


Jack
jack knob screws
battery tray part
engine blower assembly (includes the back half that has the 4 studs that go though to the outside of the frame) (works)


Clutch / break peddle assembly [gone]
2x break light / cruse control switches
Break booster + once way vacuum check valve
Master break cylinder

[This message has been edited by Wire (edited 08-29-2010).]

pm sent

Updates on what has already been spoken for

Do you have the electric passenger side mirror, ill be up in rochester probably saturday or monday and could and pick it up, might also be interested in a driver side headlight motor if yours still work, just shoot me a price

The mirrors are spoken for (I just have to dig them out and test them)

I do have both headlights available and they worked when I took the car apart.
I can hook the drivers side up tonight and verify it.

Since your going to be in the area if you need any other little odds n ends or any big items let me know.

Ya id need a drivers side headlight motor and some door molding on the passenger side. Maybe a few other things depending on what i find out about the car. What would you want for those?

Looks like the going price for the headlight assembly is $40 each. I will pull it out tonight when I get home and test it.
Depend on which trim pieces your looking for. In general a buck or two but if your looking for a bunch of parts make a pile and a offer

P.S. drop me a note when your planning on heading though. I have some plans around 1pm on Sat, Sunday is open, and Monday I have work so will not be home until about 5.

[This message has been edited by Wire (edited 03-05-2010).]

Added carpet pad, break peddles / related items, wheel well liners, Seat carpet buckets, Seats, Sail windows, AC system.

Posted a ton of stuff. I think I have pictures of everything in the shed except the doors (dam those things are heavy don't want to lug them up the hill in the snow)
Garage is next. (Tranny, frame, and a bunch of little stuff.)
Barn some other day (large body panels)

Pm for one of the Axle outers received.
Holding one till Friday. Other axle (your pick) + rest of the first still available (is there any value over scrap to what is left of the first axle???)

Got my parts shipped fast. If it was ebay I would say great ebay experience. Its not so you just get a thanks and +

Glad to hear it! Enjoy the parts

Both headlights and the engine harness are back up for grabs. (Original requesters if you still want them please respond to my PMs)

Shift cables and shifter shipped to 17113?

Thanks!

Yep I have the cables and shifter will get you a quote tonight when I get home

Can you measure the length of the cables for me? The transmission doesnt matter to me, just the length.

Thanks!

Yep will do that tonight.

Hi wire, you have a pm.

Got it just replied

You have a new PM and payment.

Front Bumper and impact absorber received!!!! Wire shipped with greyhoud and indeed the cheapest shipping for that size part. Great condition when it arrived as well!!!!!

Power mirrors and harness sold.

Should have the steering column and HVAC stuff posted this weekend.

I need one of the double hump heater line holders that secure the tubes along the gas tank. It is held on by a single 7mm screw in the center. I can PayPal. PM me.

Jonathan

Got my part. Everything was fine.

The Pictures in this thread are GREAT! Hopefully they can be kept around as they will be helpful for future projects!

Thanks for the update Scott.

I have been pulling the pictures down as I sell stuff. But if anyone wants to start a thread of them somewhere else I can re upload them all.

quote Originally posted by Wire: Thanks for the update Scott. I have been pulling the pictures down as I sell stuff. But if anyone wants to start a thread of them somewhere else I can re upload them all.

Can some one who knows how to this make it happen?.....

Just added a ton of stuff. Garage and shed are now finished.

Need to run out to the barn where I am storing my body panels and take photos of them.

Instrument cluster, lens
Front turn signals
Front marker lights
Passenger side axle "outer" rest of shaft + 2 good boots still up for grabs.

all sold (lists updated to match)

[This message has been edited by Wire (edited 03-14-2010).]

I paid for the air canister bracket, horn button and rubber intake hose, as you already know, so thank you

I just wanted to add that this has to be the best mall listing I have ever seen. Very clear thumbnails that are linked to high resolution images, and excellent descriptions. I wish all items in the mall were listed this well!

yep box is sitting in the hallway ready to go to the post office in the morning

I try my bet to keep things clear but the down side is one LONG posting (take a few minutes to update every time I change it)

Still have a few more odds and ends (mostly body panels) to go though may get to it on Wednesday night if all goes well.

Front license plate bracket sold

added some new / better pictures of the steering wheel