For Sale: $65 Shipped

Sets available - 3 (October 17, 2009)

3/8 Feed Line

5/16 Return

Both Stainless Steel Weave

Both Equipped With Quick Disconnects for any GM Vehicle

These are perfect for just about any modern swap: 3.4 DOHC, 3800 S1-S2-S3, LSx, North*, Pretty sure the ecotec, or any newer engine that utilizes the modern 3/8- 5/16 quick disconnect. Each line is approximately 30" long. Ends opposite the quick disconnects are about 3 inches of harline, which makes them perfect for flaring or a compression fitting. I used compression fittings on my L67 with a High Pressure 255 LPH Walbro pump, no leaks or concerns. They look sweet!











-----------------------------
1988 Black GT - 3800 supercharged 5 speed

[This message has been edited by Emc209i (edited 10-19-2009).]

I will take both sets--PM me payment info

[This message has been edited by MstangsBware (edited 01-29-2009).]

PM sent.

if he backs out I need a set

Definetley interested in a set for my DOHC

Pretty sure both sets are spoken for, but I might be able to track more down.

Found more and sent out pm's, waiting on replies.

Where did you get these, do you have more? Quite interested.

Still waiting on several pm's, but it may turn out I have an extra set if someone backs out.

March 03-

I have two sets available.

[This message has been edited by Emc209i (edited 10-19-2009).]

PM sent, i forgot to ask but what kind of connector is on the other end?

Replied.

quote Originally posted by Emc209i: The other end of each line has a hard line section, which makes them perfect for flaring or a compression fitting. I used compression fittings on my L67 with a HP 255 LPH Walbro pump, no leaks or problems, and they look sweet.

Compression fittings cost about $8.00 at my local hardware store. All you need is a cutoff wheel (hacksaw) and two wrenches to install both fittings. You can see how I did mine in the picture in the original post.

This one:


And these are what they look like before burning off the nylon and adding the fittings:

[This message has been edited by Emc209i (edited 03-03-2009).]

If you have a set left, I am in. Sending PM.

There are buyers for each set two times over, so I'm sure both will be spoken for by tonight. I will do my best to get more.

March 24th - I have two sets for sale again.

-Both sold.

[This message has been edited by Emc209i (edited 03-25-2009).]

I have two available.

That section that must be coupled to the OEM hard line... Is it the same diamater? I'd like to use a flare. Is it sized to mate properly? If so, I'll take a set.

Yes, same OD. A flare would work great. PM sent.

Payment sent via paypal. Thanks.

i will take one set if you still have tried to get one last time thanks brian do you paypal

I do do paypal. Got your name on it. PM sent.

That's all for this batch folks.

paypal sent

I have three sets for sale. A forth is pending.

payment sent!

Bump, three left.

Top.

Got some pictures from my good friend Mr.Pbody today.





Those are going to look great!

One, potentially two, are left.

PM sent

PM sent

Replied. All lines are spoken for.

I have three sets.

Bump.

Up.

Wednesday bump.

PM sent

Greg

[This message has been edited by FieroGTguy (edited 10-21-2009).]

Shipped lines out this morning. I still have a set left.