Up for sale is the ultimate clutch setup. I purchased this from West Coast Fiero. It is a 9 11/16 sintered Iron 6 puck, and 9 11/16 McCloud pressure plate. I am also including the flywheel (which has been machined for the fiero) with this since I do not need it any longer. I'm including the flywheel bolts as well. This setup was holding 380whp successfully with drag radials on my 3800SC. I have decided to swap from manual to built automatic. Never did I have worries about this clutch setup. This is the only clutch setup I found that would reliably hold the power without slipping.
Most companies will tell you that the iron 6 puck is too harsh for daily driving. I personally disagree. It does chatter slightly, but so does every other puck type clutch I have driven on every other car. Its nothing your wife will be able to just jump in and drive, but after adjusting to it you can drive it smoothly. (and so could your wife) Also, there is nothing else out there that will hold the power, so I guess its a moot point if you need this type of holding power.
I am looking for $300 + shipping OR BEST OFFER. Thats a HUGE discount compared to new. The flywheel machining alone was around $100. If I remember right, the clutch was around $500 or so. The setup has about 500 miles on it. Its for sale because I've decided to swap to a built auto.
Originally posted by crash41301: Had a guy that was sounding serious but he backed out.
Although this wasn't me. I was serious, until you tried to railroad me for more money. Just remember your the one who made the offer to me, at the price you came up with, and I accepted it.
[This message has been edited by Fierofreak00 (edited 11-23-2008).]
IP: Logged
12:16 PM
crash41301 Member
Posts: 51 From: Louisville, ky Registered: Feb 2005
Although this wasn't me. I was serious, until you tried to railroad me for more money. Just remember your the one who made the offer to me, at the price you came up with, and I accepted it.
Actually it was a guy that was calling me wanting the whole bundle of stuff. Sorry, I do apologize for backing out after offering to you for a price, but its rather hard to sell to someone after being offered nearly double the price by someone else for it. I honestly had no idea there would be as much interest in a flywheel with machining done to it. I can understand your upsettedness and all I can really do is offer my apology. Its not like I accepted any money or anything though so worse case here is really just lost hopes.
That being said, sold the flywheel today, so only the clutch is available from this point out.
I'm open to any offers on the clutch. There is nothing wrong with this very low mile clutch.
