http://minneapolis.craigsli.../cto/2072344282.html
Some Work Need To Be Done, Your Thoughts?

[This message has been edited by FieroGtBandit (edited 11-27-2010).]

Bent motor rods isn't some work, that's alot of work. However if it's rust free it's a great start for a engine swap, or if you can find a good 2.8 pulled from another Fiero, that would work to.

Hold out for a better one. you can get a fiero easley for $500 needing less work than that.

Were I you, I'd take $300.00 cash & a tow dolly.All depends on what ya need it for. Too far for me to haul.

Like was said before offer 300 cash for the car and show them a little green, gets them to thinking, and then you could drop that motor out and replace with this one.
http://minneapolis.craigsli.../pts/2076751138.html

You can get a good 2.8 from the fiero Factory and be up and at'em in no time!

The car is in Wisconsin. It's rusted to crap.

It may not be rusted. Just because it is from Minni doesn't mean it is rusted. All depends on how it has been cared for. I say look it over, check it out real well, then haggle and horsetrade. The worse the seller can do is say no thanks.

haha I was actually looking at those just now..... I'd go for the red se if its still up there.