Pennock's Fiero Forum
  General Fiero Chat - Archive
  LF L67 4speed mounts in CAD

T H I S   I S   A N   A R C H I V E D   T O P I C

Email This Page to Someone! | Printable Version

LF L67 4speed mounts in CAD by 86GTFastback
Started on: 08-20-2010 02:36 PM
Replies: 0
Last post by: 86GTFastback on 08-20-2010 02:36 PM
Posts: 347
From: Marion, OH, US
Registered: Apr 2009

Feedback score: (3)
Leave feedback

Rate this member

Report this Post08-20-2010 02:36 PM Click Here to See the Profile for 86GTFastbackSend a Private Message to 86GTFastbackDirect Link to This Post
Not wanting to reinvent the wheel, and mainly save me a ton of time, does anyone happen to have made L67 + 4speed mounts (pre 88) in a CAD program?

Or if someone could make measurements and pictures of theirs so someone skilled in a CAD program could draw them up for everyone?

I also would be looking for the similar in N* throttle body conversion plate, and lower mounting alternator mount.

IP: Logged
System Bot

All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock