I have a set of automatic and manual axles. Im putting an auto in my fiero so therefore (i don't need the Manual axles) and might sell them.

Approx what are they worth?

[This message has been edited by Fiero Reagan (edited 07-16-2010).]

You will want to keep the driver's side rear manual axle to use on your swap.
The manual transmission axles are beefier than the auto axles.
When installing your drivetrain, locate the driver's side transmission output shaft in exactly the same position as the Fiero transmission output shaft.
The Fiero manual trans driver's side axle will then be a perfect fit.
Depending on which trans you are using, you may be able to use a driver's side manual transmission axle on the passenger side and only change the inner tripot and spider.

By the way, all Fiero manual transmission axles are the same, other than the difference in length from driver's side (short) to passenger side (long).

Good luck with your swap, and keep the fuel injection (saw your other thread).

"New" remanufactured ones are under $60 http://www.rockauto.com/cat...249152,parttype,2288

------------------
My World of Wheels Winners (Click on links below)

3.4L Supercharged 87 GT and Super Duty 4 Indy #163

Thanks, yea I noticed that I need it after posting this lol.

quote Originally posted by Fiero Reagan: I have a set of automatic and manual axles. Im putting an auto in my fiero so therefore (i don't need the Manual axles) and might sell them. Approx what are they worth?

You can get $40 from some vendors for just the outer CV...So $40 plus shipping for them seen fair.....

http://www.fiero.nl/forum/Forum4/HTML/049788.html

If the boots are bad you can sell what is left to Archie