Pennock's Fiero Forum
  General Fiero Chat - Archive
  hey northern Va. I need a 2.8 bellhousing and clutch

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
hey northern Va. I need a 2.8 bellhousing and clutch by Francis T
Started on: 07-02-2010 09:38 PM
Replies: 1
Last post by: Francis T on 07-02-2010 09:39 PM
Francis T
Member
Posts: 6620
From: spotsylvania va. usa
Registered: Oct 2003

Feedback score: (1)
Leave feedback





Total ratings: 119
Rate this member
Report this Post07-02-2010 09:38 PM Click Here to See the Profile for Francis TClick Here to visit Francis T's HomePageSend a Private Message to Francis TDirect Link to This Post
Neither need to be any good. I just want to add them to my mule engine for test fitting of headers and turbo mountng brackets etc. As you can see, I'll need to make a special cradle to hold engine so I put a bellhousing it.



IP: Logged
PFF
System Bot
Francis T
Member
Posts: 6620
From: spotsylvania va. usa
Registered: Oct 2003

Feedback score: (1)
Leave feedback





Total ratings: 119
Rate this member
Report this Post07-02-2010 09:39 PM Click Here to See the Profile for Francis TClick Here to visit Francis T's HomePageSend a Private Message to Francis TDirect Link to This Post
Ops, I don't need a clutch just an old slave cylinder.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock