muncie 4 spd tansmission leaking

Click here to visit The FieroStore | View all sponsors

Pennock's Fiero Forum

General Fiero Chat - Archive

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

muncie 4 spd tansmission leaking by 1984whitesc

Started on	: 06-29-2006 08:40 PM
Replies	: 4
Last post by	: lurker on 06-29-2006 10:41 PM

1984whitesc
Member

Posts: 1043
From: Clayton, WI USA
Registered: Jun 2006

Feedback score: (1)
Leave feedback

Rate this member

Report this Post06-29-2006 08:40 PM

Click Here to visit 1984whitesc's HomePage

I have a leaking muncie 4 speed. It looks to be right where the drive axles come out. Do any of you have any suggestions on how to fix it with out going to a shop, I can't afford $350+. I have the drive axle seal.

[This message has been edited by 1984whitesc (edited 06-29-2006).]

IP: Logged

PFF

System Bot

olaf_fiero27
Member

Posts: 967
From: winnipeg,manitoba,Canada
Registered: Oct 2004

Feedback score: (2)
Leave feedback

Rate this member

Report this Post06-29-2006 10:02 PM

Take out the axle that is leaking. Get a seal puller and carefully pull the seal out of the transmission but be careful not to gouge the soft aluminum that the trans is made of. Now the tough part is putting the new ones in. I got a peice of 2" PVC pipe and used a dremel until the inside diameter was perfect for the seal. Now drive it in with a hammer, which is a PITA. Once you got it going make sure it's going in straight and keep banging it in until the flange of the seal is flush with the transmission. Good Luck!

IP: Logged