Well I was working on my poly swap yesterday but hit a snag, the rear lower control arm bolts are stuck and can't get them out. The nuts came off, and you can spin the bolt it's just stuck. So can I take say a 3inch wheel and cut inbetween the arm and cradle where the bushing end is?

Yes. If you can get in there with a wheel, go nuts. I had to use a sawzall when I did mine.

Stuck bolts can be removed... w/o cutting.
See my cave, bushing in suspension section.

------------------
Dr. Ian Malcolm: Yeah, but your scientists were so preoccupied with whether or not they could, they didn't stop to think if they should.
(Jurassic Park)

The Ogre's Fiero Cave (It's also at the top and bottom of every forum page...)