Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Motor mount bolt size and thread

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Motor mount bolt size and thread by masospaghetti
Started on: 09-27-2011 10:01 PM
Replies: 3
Last post by: masospaghetti on 09-29-2011 12:20 PM
masospaghetti
Member
Posts: 2477
From: Charlotte, NC USA
Registered: Dec 2009

Feedback score:    (10)
Leave feedback

Rate this member
Report this Post09-27-2011 10:01 PM Click Here to See the Profile for masospaghettiSend a Private Message to masospaghettiDirect Link to This Post
Went out and found one of the bolts missing in one of my mounts!

I don't have a pic at the moment, but it's the L-shaped bracket on the passenger side just aft of the crank pulley...its the bolt right in the middle of this pic: http://gallery.fierodomain....sRemoved001.JPG.html

What is the size and pitch of this sucker? Thx all!

It's a 86 GT.
IP: Logged
PFF
System Bot
Bloozberry
Member
Posts: 7760
From:
Registered: Jan 2009

Feedback score: N/A
Leave feedback





Total ratings: 311
Rate this member
Report this Post09-28-2011 07:59 AM Click Here to See the Profile for BloozberrySend a Private Message to BloozberryDirect Link to This Post
The P22 shows the bolt clearly but doesn't give the detailed specs about its dimensions . I have a couple spare engines in the work shop and will go measure one up for you within the next two hours unless someone else replies before then.
IP: Logged
Bloozberry
Member
Posts: 7760
From:
Registered: Jan 2009

Feedback score: N/A
Leave feedback





Total ratings: 311
Rate this member
Report this Post09-28-2011 09:15 AM Click Here to See the Profile for BloozberrySend a Private Message to BloozberryDirect Link to This Post

Bloozberry

7760 posts
Member since Jan 2009
As promised:

M12 X 1.75 X 75 (10.9) where:

M = metric
12 = diameter in mm
1.75 = thread pitch
75 = length of bolt under the head
10.9 = metric grade

Note too that there's a fairly thick washer (~ 3mm) used under the head of the bolt. The bolt also had blue locktite on the threads.
IP: Logged
masospaghetti
Member
Posts: 2477
From: Charlotte, NC USA
Registered: Dec 2009

Feedback score:    (10)
Leave feedback

Rate this member
Report this Post09-29-2011 12:20 PM Click Here to See the Profile for masospaghettiSend a Private Message to masospaghettiDirect Link to This Post
Awesome, thanks a bunch Blooz...I owe ya!
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock