Ok, Relocating my starter on the 3.4 and I am using the jig kit that I barrowed from Misery. Please pardon my Paranoia, but I really, really do not want to mess this up. The kit didn't have the tap and I am stranded right now with no vehicle to get to the auto parts store. TIA

------------------
Peace!!

B2
86GT Project

I had always understood the bolts were the same for all Fiero starters. IF this is true, then this should help.

quote From your description, you need the inboard bolt, the short bolt. Looking in the P-22 manual, the bolt size is : 10mm x 46mm. p/n 14001842, still is listed at GMPartsDirect, GM list is $4.25, looks like a common part, so any GM dealer should have it in stock. As reference for others, the longer bolt, size: 10mm x 114mm, p/n 14001841, no longer listed on-line, the part number could have change. As Jazzman noted, the bolt has a special shoulder for use with starters.

https://www.fiero.nl/forum/A...100421-2-090371.html

10mm x 1.5 thread pitch

Cool, thanks!! That is half of the equation. Now, what size bit to use to drill the starter holes?

------------------
Peace!!

B2
86GT Project

8.5 mm

[This message has been edited by phonedawgz (edited 09-30-2010).]