Installing Autometer Gauges? - Pennock's Fiero Forum

Click here to visit The FieroStore | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

Installing Autometer Gauges?

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

Installing Autometer Gauges? by Logan

Started on	: 04-27-2010 10:07 AM
Replies	: 4
Last post by	: joshua riedl on 04-27-2010 07:20 PM

Logan
Member

Posts: 263
From: Terre Haute, IN
Registered: Jun 2009

Feedback score: (1)
Leave feedback

Rate this member

Report this Post04-27-2010 10:07 AM

Send a Private Message to Logan

Direct Link to This Post

Hey I was wondering How hard it would be to install a Full Set of autometer gauges .. All the Gauges like .. water temp., Fuel level, speedo, tach, oil pres, voltmeter, trans temp...... My vehicle is an 87 se with a 97 3800 series 2 swap- transmission is a 4t-60e..

Thank you

IP: Logged

PFF

System Bot

Logan
Member

Posts: 263
From: Terre Haute, IN
Registered: Jun 2009

Feedback score: (1)
Leave feedback

Rate this member

Report this Post04-27-2010 10:16 AM

Send a Private Message to Logan

Direct Link to This Post

i was thinking the c2 gauges or the colbalts

IP: Logged

Ang84Indy
Member

Posts: 576
From: Ohio
Registered: Jul 2009

Feedback score:

(7)
Leave feedback

Rate this member

Report this Post04-27-2010 10:22 AM

Send a Private Message to Ang84Indy

Direct Link to This Post

I think the panel is deep enough to house Autometer gauges without reconstructing the Dash. New gauges is on my list of things to do, and I don't want to do major reconstruction.

IP: Logged

IFLYR22
Member

Posts: 1775
From: Tucson, AZ.
Registered: May 2007

Feedback score: N/A
Leave feedback

Rate this member

Report this Post04-27-2010 11:52 AM

Send a Private Message to IFLYR22

Direct Link to This Post

I did. it was not that hard.

//www.fiero.nl/forum/Forum2/HTML/087647.html

-Dave

adding: about halfway down shows what I did for the main pod, including a wire pin-out for all the gauges. This was done on an 85 with 3800S2 and auto 4T65E-HD.

[This message has been edited by IFLYR22 (edited 04-27-2010).]

IP: Logged

joshua riedl
Member

Posts: 1426
From: watertown wi USA
Registered: Jan 2004

Feedback score: N/A
Leave feedback

Rate this member

Report this Post04-27-2010 07:20 PM

Send a Private Message to joshua riedl

Direct Link to This Post

My C2's. install was easy enough.

IP: Logged

All times are ET (US)


T H I S I S A N A R C H I V E D T O P I C

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock