I bought a new connector for an 88 oil sender unit at FS but all wires are white.

It is for my 4.9 swap, and for now I have no access to my Formula so I am looking for someone who can identify the wires for me.

Colors are Tan, Tan-Wht and Org-Blk.

Pictures:



------------------
"I'm not driving too fast, . . . I'm just flying too low."

4.9 ongoing project

[This message has been edited by falcon_ca (edited 10-24-2009).]

The center one should go to tan (oil gauge) The two outside dont matter its just the on off switch for the fuel pump. Tan/white is to the pump, orange is 12v feed.

from this picture left to right




left - light tan with white stripe

middle - solid light tan

right - Orange with brown or blk stripe

is the orange with black stripe a general 12v supply wire? i have 2 random ones and two relays ( fuel pump and AC and it would make sense if one went to each)
(no hyjacking ment)
Ryan

Two orange/black near the relay ? Those both connect to the same pin on the fuel pump relay, one feeds from the fuse, the other runs to the oil pressure switch.

Thanks Gentlemen

------------------
"I'm not driving too fast, . . . I'm just flying too low."

4.9 ongoing project