I am in the process of building the engine harness for the swap of a 91 4.9 V8 into my Formula.

I follow the instructions from different threads, there is a lot of them, and they are all interesting.

I bought a temperature sender with three connectors as suggested in Mickey_Moose's thread and he is talking about pin "A" black wire , "B" yellow wire and pin "C" green wire.

I have no clue which one is pin A, B or C on the sender , and my connector has different colors.

Is there someone who can help me identify the pins using this picture?

------------------
"I'm not driving too fast, . . . I'm just flying too low."

4.9 ongoing project

I think the male connector has the letters that correspond

quote Originally posted by CC Rider: I think the male connector has the letters that correspond

Not on mine

'C' is the pin by itself. So as this plug turns up side down to plug into your sensor the left is 'B', and 'A' is right
Joe Crawford

[This message has been edited by josef644 (edited 10-07-2009).]

Thanks Joe

I found it while you were answering