Hi I posted it in the general by mistake so I will start agian in here.
I am using the steering column from a Vauxhall corsa sxi
Here is a pic of the modified shaft. I forgot to take a pic of the one using an 88 damperrerd one.
After that is was just a case of fabricating a mounting brracket
Some progress. I got the steering colum mounted
The controller documentation and the controller
Did some work on the stalks today. Had to cut out the resistors that bridged the contacts
Then I connected the wirres for the switched points
Managed to build a circuit that when the stalk is pushed forward it toggles high beam and push again to disengage it.
[This message has been edited by northeastfiero (edited 08-14-2009).]