'88 exhaust gasket source? - Pennock's Fiero Forum

Click here to visit The FieroStore | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

'88 exhaust gasket source?

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

'88 exhaust gasket source? by psychosurfer

Started on	: 09-14-2008 10:45 AM
Replies	: 2
Last post by	: StockGT on 09-14-2008 03:49 PM

psychosurfer
Member

Posts: 2014
From: Jefferson, GA USA
Registered: Mar 2006

Feedback score:

(6)
Leave feedback

Rate this member

Report this Post09-14-2008 10:45 AM

Send a Private Message to psychosurfer

Direct Link to This Post

Got an exhaust flange gasket (donut gasket) for an '88 v6 auto from Auto Zone, one from Advance and one from Napa. None of them are correct. The tin metal inside sleeve is too small a diameter on each of them to fit over the flange part on the factory cross-over. Any ideas on where to get a correct one? Anyone else have the same problem?

IP: Logged

PFF

System Bot

IMSA GT
Member

Posts: 10681
From: California
Registered: Aug 2007

Feedback score:

(8)
Leave feedback

Total ratings: 253
Rate this member

Report this Post09-14-2008 11:11 AM

Send a Private Message to IMSA GT

Direct Link to This Post

Fiero Store has them for $11.00

IP: Logged

StockGT
Member

Posts: 386
From: O.C. , California
Registered: Feb 2007

Feedback score: N/A
Leave feedback

Rate this member

Report this Post09-14-2008 03:49 PM

Send a Private Message to StockGT

Direct Link to This Post

I ordered one from PartsAmercia / Advance, sent out NEA brand, EX-40, same fit problem as you described.
Picked up another from PepBoys, fit correctly, it was a Fel-Pro, p/n 60650.It's listed for use on 85-86 V6 Fieros.

IP: Logged

All times are ET (US)


T H I S I S A N A R C H I V E D T O P I C

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock