Fells,
Do the side mirrors of the Fiero accept any other car? I think someone once told me that Corvette mirrors are an exact remove and replace. I would love to get the stock Corvette de-fogger to work on my Fiero. Any ideas?

Cordially,
Kevin

Talk to jscott, he has corvette mirrors on his car.

OK jscott, what year Corvette did you use?

Cordially,
Kevin

The Fiero outside mirror glass is the same as 84-96 Corvette, 82-93 Firebird, 82-92 Camaro, 86-88 El Camino, 78-88 Monte Carlo, 86 Caprice & Impala and 85-88 Caballero & Sprint. Not sure if any or all the housings will bolt up.

[This message has been edited by spark1 (edited 05-22-2008).]

The Camaro housing is slightly different, sits lower or something, hard to explain. I have a Camaro power mirror on my passenger side, and it kinda sags down...

------------------

1984 Fiero SE

I put heated C4 Vette mirror glass in my Fiero. The glass is the same size but I found that the motor drive pins were 90 deg out. I hunted around in my parts bucket and came up with some Fiero mirror shells that would accept the Vette motor brackets. Seems that the GM used about 3-4 different setups in the mirror shells.

I got some Camaro power mirrors (used the Fiero shell/case) and installed into the Fiero without problems in that area. Inside I used the Ford switch that can be installed at the stock door mirror knob.

The answers are all here.

//www.fiero.nl/forum/A...050410-2-057316.html

The shells are different between Fiero and C4 and Firebird /Camaro and others. It wasn't close enough for my taste, so I have the Corvette glass and motors, (which do mate even though it's 90 degree out) mounted in the Fiero shells.

Actually on my chop top I switched to 96 Aurora mirrors. They are not 100% bolt-up but can be made to fit. I have the heated ones on the Indy now.

[This message has been edited by jscott1 (edited 05-22-2008).]