Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Camaro Flywheel

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


Camaro Flywheel by FieroProject07
Started on: 05-08-2008 10:28 PM
Replies: 4
Last post by: Dementia on 05-09-2008 08:01 AM
FieroProject07
Member
Posts: 31
From: Langley, BC, Canada
Registered: Nov 2005


Feedback score: N/A
Leave feedback

Rate this member

Report this Post05-08-2008 10:28 PM Click Here to See the Profile for FieroProject07Send a Private Message to FieroProject07Direct Link to This Post
Hey all. I just received a flywheel I ordered for my 3800 S/C swap. However, I'm not sure that this is the correct one. Judging by the pics, do you guys know if this is indeed the correct flywheel?





IP: Logged
PFF
System Bot
Matthew_Fiero
Member
Posts: 2932
From: Canada
Registered: Aug 2001


Feedback score: (1)
Leave feedback





Total ratings: 51
Rate this member

Report this Post05-08-2008 10:41 PM Click Here to See the Profile for Matthew_FieroSend a Private Message to Matthew_FieroDirect Link to This Post
Looks good to me!

Now take about half an inch off that surface face, bolt a pressure plate on it and go get it balanced!
IP: Logged
FieroProject07
Member
Posts: 31
From: Langley, BC, Canada
Registered: Nov 2005


Feedback score: N/A
Leave feedback

Rate this member

Report this Post05-08-2008 10:44 PM Click Here to See the Profile for FieroProject07Send a Private Message to FieroProject07Direct Link to This Post
This may be a dumb question, but do I use the Pressure plate for the fiero or the camaro. The reason I have no idea is because I haven't seen either the Fiero flywheel or the Camaro flywheel, as both of them are located at my brothers house 3 provinces away.
IP: Logged
Matthew_Fiero
Member
Posts: 2932
From: Canada
Registered: Aug 2001


Feedback score: (1)
Leave feedback





Total ratings: 51
Rate this member

Report this Post05-08-2008 11:13 PM Click Here to See the Profile for Matthew_FieroSend a Private Message to Matthew_FieroDirect Link to This Post
Fiero
IP: Logged
Dementia
Member
Posts: 958
From: warren,OH
Registered: Jul 2007


Feedback score:    (11)
Leave feedback

Rate this member

Report this Post05-09-2008 08:01 AM Click Here to See the Profile for DementiaSend a Private Message to DementiaDirect Link to This Post
Mines at the machine shop now. From every thread I've read on here it needs turned down to 0.84 from crank face to clutch face so its roughly a 1/4" taken off. You will need an SC auto flex plate to set your balance to.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock