ok i know you can jump the aldl to go into code mode? or something like that but i was wondering can you do this on an 1989 camaro 5.0 tbi? if so does anyone kno where i can get a list of codes and can someone tell me what wires to jump to get ecm into code mode or what ever its called?


srry i kno its a little off topic i posted here hoping to get a quick reply

If you have access to a computer that is connected to the internet, you could use Google to quick search..

If you don't, then here is a good link I got from a quick Google search: http://www.bnb32.com/readarticle.php?article_id=14

quote Originally posted by Poncho Jim: If you have access to a computer that is connected to the internet, you could use Google to quick search.. If you don't, then here is a good link I got from a quick Google search: http://www.bnb32.com/readarticle.php?article_id=14

isnt that what i need? the 89 is third or second gen?

quote Originally posted by DEMONCHILD: isnt that what i need? the 89 is third or second gen?

Gen I 1967-69
Gen 2 1970-81
Gen 3 1982-92
Gen 4 1993-end of production

...but if you couldn't figure that out, I'm not holding out much hope for you being able to successfully complete your own diagnostic and repair on an automobile.

Oh yeah, and: http://www.thirdgen.org/techboard/
Check mostly under DIY PROM and DFI - ECM.

[This message has been edited by KurtAKX (edited 03-28-2008).]