Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Clunking from R to F

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


Clunking from R to F by emsdad
Started on: 03-19-2008 06:57 PM
Replies: 2
Last post by: Doc John on 03-19-2008 07:11 PM
emsdad
Member
Posts: 251
From: Va
Registered: Mar 2008


Feedback score: N/A
Leave feedback

Rate this member

Report this Post03-19-2008 06:57 PM Click Here to See the Profile for emsdadSend a Private Message to emsdadDirect Link to This Post
What causes the clunk when shifting from reverse to forward?
IP: Logged
PFF
System Bot
Doc John
Member
Posts: 749
From: Fayetteville, Arkansas
Registered: Feb 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post03-19-2008 07:00 PM Click Here to See the Profile for Doc JohnSend a Private Message to Doc JohnDirect Link to This Post
Worn out bushings in the dogbone mount, and/or worn motor/trans mounts (the former leads to the latter).
IP: Logged
Doc John
Member
Posts: 749
From: Fayetteville, Arkansas
Registered: Feb 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post03-19-2008 07:11 PM Click Here to See the Profile for Doc JohnSend a Private Message to Doc JohnDirect Link to This Post
As a test you could have someone watch for motion at the dogbone while you shift from D to R. I had an 88 4 cyl that moved a huge amount when I selected D or R. Ultimately I ended up replacing the motor & trans mounts as well as the dogbone.

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock