Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Aluminum oil pan for stock V6 2.8 ?.

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


Aluminum oil pan for stock V6 2.8 ?. by Torch-Red87
Started on: 02-18-2008 04:47 PM
Replies: 2
Last post by: Torch-Red87 on 02-19-2008 04:46 AM
Torch-Red87
Member
Posts: 314
From: Stuttgart, Germany
Registered: Aug 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post02-18-2008 04:47 PM Click Here to See the Profile for Torch-Red87Click Here to visit Torch-Red87's HomePageClick Here to Email Torch-Red87Send a Private Message to Torch-Red87Direct Link to This Post
Does anyone know , is there a aluminum oil pan that fit the stock V6 2.8 ?.

Thank you for your answer !!.

[This message has been edited by Torch-Red87 (edited 02-18-2008).]

IP: Logged
PFF
System Bot
Steven Snyder
Member
Posts: 3311
From: Los Angeles, CA
Registered: Mar 2004


Feedback score: (2)
Leave feedback





Total ratings: 106
Rate this member

Report this Post02-18-2008 08:24 PM Click Here to See the Profile for Steven SnyderClick Here to visit Steven Snyder's HomePageClick Here to Email Steven SnyderSend a Private Message to Steven SnyderDirect Link to This Post
There is no aluminum pan for the 2.8. The next generation engines had an aluminum pan but the bolt pattern is different. It's my understanding that there isn't material in the right places for drilling out to fit the aluminum pan. It would require main bearing cap modifications as well since it is for crossbolted mains. This would require line boring the engine..
IP: Logged
Torch-Red87
Member
Posts: 314
From: Stuttgart, Germany
Registered: Aug 2004


Feedback score: N/A
Leave feedback

Rate this member

Report this Post02-19-2008 04:46 AM Click Here to See the Profile for Torch-Red87Click Here to visit Torch-Red87's HomePageClick Here to Email Torch-Red87Send a Private Message to Torch-Red87Direct Link to This Post
Well i tought that there is maybe from a other 60 V6 2.8 an oil pan from aluminum that will fit the Fiero as well !. Hmmm pretty bad there is non .
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock