Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Clutch Removal

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


Clutch Removal by fffttt1
Started on: 02-04-2008 10:33 AM
Replies: 1
Last post by: Dodgerunner on 02-04-2008 10:43 AM
fffttt1
Member
Posts: 662
From: Granbury, TX.
Registered: Jun 2004


Feedback score: (2)
Leave feedback

Rate this member

Report this Post02-04-2008 10:33 AM Click Here to See the Profile for fffttt1Send a Private Message to fffttt1Direct Link to This Post
I have aluminum cradle bushings installed. Can I remove the rear mounts only and use the "tilt" method to remove my clutch?
Thanks, Ray.
IP: Logged
PFF
System Bot
Dodgerunner
Member
Posts: 9684
From: Lincoln, Nebraska
Registered: Sep 2004


Feedback score:    (61)
Leave feedback





Total ratings: 323
Rate this member

Report this Post02-04-2008 10:43 AM Click Here to See the Profile for DodgerunnerClick Here to visit Dodgerunner's HomePageSend a Private Message to DodgerunnerDirect Link to This Post
I don't know how the front bushing work so I'd say yes you can but you might want to just loosen the front bolts to let it pivot easier. I don't know how tight the AL bushing are...

Otherwise there should be no difference.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock