Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  brake upgrade help

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


brake upgrade help by 10secondfiero
Started on: 01-07-2008 09:38 PM
Replies: 0
Last post by: 10secondfiero on 01-07-2008 09:38 PM
10secondfiero
Member
Posts: 17
From: La-La Land
Registered: May 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post01-07-2008 09:38 PM Click Here to See the Profile for 10secondfieroClick Here to Email 10secondfieroSend a Private Message to 10secondfieroDirect Link to This Post
i just installed a brake upgrade on the back of my fiero useing the lebaron rotors and cadillac calipers. i also installed a new booster and master cylinder (s10), put new one man bleeder screw on all for corners. i have the rotors and calipers for the front but im going to wait a couple of weeks to do the fronts. i have bleed the brakes atleast 5 times and still cant get the brakes to pump up. the brakes bleed good with no air in the lines.
im thinking it has something to do with the rear e brake setup. the drivers side e brake cable broke while i was hooking it back up. i can push down the on the e brake spring and it will hold the rotor. no matter what i do the pedal just goes to the floor...... i just dont know what to do now......any ideas???
IP: Logged
PFF
System Bot



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock