Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  o-rings r134 sizes - ac experts needed.

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
o-rings r134 sizes - ac experts needed. by pprbart@cs.com
Started on: 12-14-2007 08:05 PM
Replies: 1
Last post by: StockGT on 12-14-2007 08:22 PM
pprbart@cs.com
Member
Posts: 220
From: troy, mi, usa
Registered: Jun 2002

Feedback score: N/A
Leave feedback

Rate this member
Report this Post12-14-2007 08:05 PM Click Here to See the Profile for pprbart@cs.comSend a Private Message to pprbart@cs.comDirect Link to This Post
i am updating to r134. i have purchased two set of o rings from ac shops and each set has a smaller ring cross section than the r12
originals. the id's of the rings are generally the same. is this normal. both sets are for gm use.
IP: Logged
PFF
System Bot
StockGT
Member
Posts: 386
From: O.C. , California
Registered: Feb 2007

Feedback score: N/A
Leave feedback

Rate this member
Report this Post12-14-2007 08:22 PM Click Here to See the Profile for StockGTSend a Private Message to StockGTDirect Link to This Post
Here's the link to the question I posted about AC O-rings sizes.

https://www.fiero.nl/forum/Forum2/HTML/085492.html
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock