Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Trashed rear tranny mount

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


Trashed rear tranny mount by Bubbajuju
Started on: 10-16-2007 12:39 AM
Replies: 12
Last post by: MstangsBware on 10-16-2007 04:19 PM
Bubbajuju
Member
Posts: 548
From: Oklahoma
Registered: Sep 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post10-16-2007 12:39 AM Click Here to See the Profile for BubbajujuSend a Private Message to BubbajujuDirect Link to This Post
I knew that motor was rocking around but dang! The rear tranny mount "bracket" is in four peices! The front one is broken as well but at the mount. I don't think there is enough of the rear one to weld up (as thin as the thing is anyway).

Anybody got any ideas? The parts stores just have the lower section of the mount.

Anyone ever find these mount brackets new anywhere?

Thanks.
IP: Logged
PFF
System Bot
MstangsBware
Member
Posts: 11509
From: TEXAS
Registered: Mar 2002


Feedback score:    (108)
Leave feedback





Total ratings: 459
Rate this member

Report this Post10-16-2007 01:54 AM Click Here to See the Profile for MstangsBwareSend a Private Message to MstangsBwareDirect Link to This Post
What trans is the for?
IP: Logged
Will
Member
Posts: 14284
From: Where you least expect me
Registered: Jun 2000


Feedback score: (1)
Leave feedback





Total ratings: 237
Rate this member

Report this Post10-16-2007 08:41 AM Click Here to See the Profile for WillSend a Private Message to WillDirect Link to This Post
Rodney Dickman ( www.rodneydickman.com ) builds upgraded trans mount brackets.
Which transmission?

My Northstar car did that. Only took a few months to beat the stock rear trans mount bracket to death. Mine split into three pieces.
IP: Logged
Bubbajuju
Member
Posts: 548
From: Oklahoma
Registered: Sep 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post10-16-2007 09:12 AM Click Here to See the Profile for BubbajujuSend a Private Message to BubbajujuDirect Link to This Post
Sorry I should mention what trans. Duh!

86 se with a 4 speed stick.

I looked at Rodney's site but I didn't see any brackets, just the bottom mounts. I'll go check again though. I think I will end up just driving it with a front mount until I find the rear bracket.

Thanks all.
IP: Logged
RideZiLightning
Member
Posts: 1540
From: Tacoma, WA
Registered: Jul 2006


Feedback score: N/A
Leave feedback





Total ratings: 153
Rate this member

Report this Post10-16-2007 09:14 AM Click Here to See the Profile for RideZiLightningSend a Private Message to RideZiLightningDirect Link to This Post
The motor could fall right out lol
IP: Logged
Rodney
Member
Posts: 4715
From: Caledonia, WI USA
Registered: Feb 2000


Feedback score: (4)
Leave feedback





Total ratings: 267
Rate this member

Report this Post10-16-2007 09:16 AM Click Here to See the Profile for RodneyClick Here to visit Rodney's HomePageSend a Private Message to RodneyDirect Link to This Post
I onlt have the steel brackets for the Getrag 5 speeds. Mainly because of people using FWD Getrags. I have not seen much need for the other 4 speed and Isuzu 5 speed brackets as they are still somewhat easy to find good used.

------------------
Rodney Dickman

Fiero Parts And Acc's Web Page:
www.rodneydickman.com
Rodney Dickman's Fiero accessories
7604 Treeview Drive
Caledonia, WI 53108
Phone/Fax (262) 835-9575

IP: Logged
Bubbajuju
Member
Posts: 548
From: Oklahoma
Registered: Sep 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post10-16-2007 09:17 AM Click Here to See the Profile for BubbajujuSend a Private Message to BubbajujuDirect Link to This Post
I can't believe it hasn't fallen out yet!! I been romping on it for a year with two shot tranny mounts and a super worn dogbone!
IP: Logged
Bubbajuju
Member
Posts: 548
From: Oklahoma
Registered: Sep 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post10-16-2007 09:19 AM Click Here to See the Profile for BubbajujuSend a Private Message to BubbajujuDirect Link to This Post

Bubbajuju

548 posts
Member since Sep 2007
Thanks Rodney,
You do however have a bunch of parts I need. Just have to wait for funds. I will try and jb weld my broken slave bracket until I can order your steel one. Thanks for all of your parts!
IP: Logged
Raydar
Member
Posts: 41200
From: Carrollton GA. Out in the... country.
Registered: Oct 1999


Feedback score:    (13)
Leave feedback





Total ratings: 461
Rate this member

Report this Post10-16-2007 10:17 AM Click Here to See the Profile for RaydarSend a Private Message to RaydarDirect Link to This Post
For the replacement brackets, post a "wanted" ad in the mall.

If nobody has them (which will really surprise me) call the Fiero Factory and tell them what you need.
www.thefierofactory.com.
I needed the same brackets for an Isuzu tranny, and they had them to me in a couple of days.

------------------
Raydar
88 4.9 Formula IMSA Fasback..........................88 3.4 coupe -soon to be something other than red

Read Nealz Nuze! Praise the Lowered!

IP: Logged
Bubbajuju
Member
Posts: 548
From: Oklahoma
Registered: Sep 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post10-16-2007 11:46 AM Click Here to See the Profile for BubbajujuSend a Private Message to BubbajujuDirect Link to This Post
Thanks Raydar
IP: Logged
Blacktree
Member
Posts: 20770
From: Central Florida
Registered: Dec 2001


Feedback score:    (12)
Leave feedback





Total ratings: 350
Rate this member

Report this Post10-16-2007 11:51 AM Click Here to See the Profile for BlacktreeClick Here to visit Blacktree's HomePageSend a Private Message to BlacktreeDirect Link to This Post
I'm with Raydar. The people at the Fiero Factory will have what you need.
IP: Logged
PFF
System Bot
Bubbajuju
Member
Posts: 548
From: Oklahoma
Registered: Sep 2007


Feedback score: N/A
Leave feedback

Rate this member

Report this Post10-16-2007 12:53 PM Click Here to See the Profile for BubbajujuSend a Private Message to BubbajujuDirect Link to This Post
I'll give them a call thanks everyone.
IP: Logged
MstangsBware
Member
Posts: 11509
From: TEXAS
Registered: Mar 2002


Feedback score:    (108)
Leave feedback





Total ratings: 459
Rate this member

Report this Post10-16-2007 04:19 PM Click Here to See the Profile for MstangsBwareSend a Private Message to MstangsBwareDirect Link to This Post
 
quote
Originally posted by Bubbajuju:

I'll give them a call thanks everyone.


I sent you a PM about the mounts.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock