Going to try to replace a broken driver side window this weekend. Anybody have any tips or things I should watch for?

Quite a few threads on this subject Just 2 of them
https://www.fiero.nl/forum/A...070315-2-077841.html
https://www.fiero.nl/forum/A...050410-2-058380.html

[This message has been edited by brandon87gt (edited 05-15-2007).]

just did this a few weeks ago.
you will probably need new clips, rivits & stuff.
quick run down - trying to remember:
remove inside arm rest, door handle/lock, mirror set hex screw, remove panel
undo rubber end caps & inside dew strip
take off outside trim strip - 'prolly will break the clips.
now, the door skin screws. they are black, w/plastic covers. the plastic will probably strip. there is a metal torx head underneath, the next size up. undo them all
last, is the plastic rivits on the underside off the door. they should break off easily.
oh yeah - the mirror - 10mm wrench
this should leave you with a stripped, ugly door. you'll need to raise/lower the glass to get access to the rivits. these will need drilling or some other way to pop out.

you can see, there is alot of fasteners being broken up. Fiero Store carries all of them, along with dew strips & weather stripping
5 trim clips, 4 window glass rivits, 5 door skin rivits

Ah, excellent timing. I just purchased new door glass and will be doing this too! +'s for the info (assuming I have not given them to you already)

Nolan

[This message has been edited by Sourmug (edited 05-15-2007).]