What is the procedure to take a dash out of a 1988 Fiero gt So i can have a look at my a/c and door operating module cause i think some doors are not operatingt well I dn't t have much flow on my heater All the fan compartement is clean no debris at all , same for the element no rust at all When i put the ac on highe the temp is cold but it sound like the air is only circulating inside the duct . And when i put the heater not much coming out of it it is hot but not much flow
IP: Logged
05:25 AM
PFF
System Bot
aerosmithr0cker Member
Posts: 1199 From: Charlotte, NC, USA Registered: Aug 2004
you have to remove the gauge cluster and surround pieces, the center radio console surround. The top speaker grilles pop out revealing 2 screws on each side that must come out. Then there is a 10mm bolt on each side of the dash underneath that runs up, one is near the fuse box and the other is on the far side near the footwell light in the passenger side. Also if you have the aux gauge pod you will need to remove it and disconnect the harness under the dash for it leaving a short section of it in the dash because it will not fit out but can be left with the dash.
