Whatever you end up getting, tey to make sure it is as close to the width dimension as possible. The seats I put in my car are 1/2 inch wider than the stock seats and they rub the center console a bit, but the factory seats did too.
You don't want to go too much wider or they won't fit. You also need to make sure the new seats aren't too high or they may hit the roof. My new seats are about 3 inches taller than the stock seats and only have about 3 or 4 inches of clearance from the roof. If you use the new seat rails that come with the new seats, they will sit about 1 inch lower. There also are other things you can do to get the seats even lower, but these are involved.
[This message has been edited by avengador1 (edited 02-22-2005).]
