O2 sensor thread size

Click here to visit the donation page | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

O2 sensor thread size by 88fierogt123

Started on	: 04-08-2004 09:38 PM
Replies	: 2
Last post by	: TK on 04-08-2004 11:57 PM

88fierogt123
Member

Posts: 202
From: Bonifay Fl us
Registered: Dec 2002

Feedback score: N/A
Leave feedback

Rate this member

Report this Post04-08-2004 09:38 PM

I pulled my O2 sensor out today in mt 88 v6 and I think I pulled out some of the threads out. not too bad, but I need to pass a tap through it. any one know what size tap?

IP: Logged

PFF

System Bot

Oreif
Member

Posts: 16460
From: Schaumburg, IL
Registered: Jan 2000

Feedback score:

(19)
Leave feedback

Total ratings: 442
Rate this member

Report this Post04-08-2004 11:01 PM

18mm, I don't remember if its a 1.0 or 1.5 thread pitch. I want to say a 1.5. This was the size of the plug I needed when I removed mine.

------------------

Happiness isn't around the corner...
Happiness IS the corner.

[This message has been edited by Oreif (edited 04-08-2004).]

IP: Logged

TK
Member

Posts: 10013
From:
Registered: Aug 2002

Feedback score: (2)
Leave feedback

Total ratings: 200
Rate this member

Report this Post04-08-2004 11:57 PM

Its an M18 x 1.5 metric thread

[This message has been edited by TK (edited 04-08-2004).]

IP: Logged

All times are ET (US)


T H I S I S A N A R C H I V E D T O P I C

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock