Cost for lower end re-build

Click here to visit The FieroStore | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

Cost for lower end re-build by jron

Started on	: 01-19-2004 07:39 PM
Replies	: 2
Last post by	: RWF on 01-19-2004 11:36 PM

jron
Member

Posts: 298
From: South Lyon, Michigan USA
Registered: Dec 2001

Feedback score: N/A
Leave feedback

Rate this member

Report this Post01-19-2004 07:39 PM

It's time to work on the new ride 85GT Notchback. It will be gitting the old motor from my 350 TPI swap also 85 Notch. It had a bad sounding knock so it needs work,any ideas on total cost for crank and bearings? I want to have this car stock V6.

Jim

IP: Logged

PFF

System Bot

TaurusThug
Member

Posts: 4271
From: Simpsonville, SC
Registered: Aug 2003

Feedback score: N/A
Leave feedback

Total ratings: 102
Rate this member

Report this Post01-19-2004 10:15 PM

im taking a wild guess at a price but if you did it yourself around 700, thats what i have found.

------------------
'86 Fiero GT

www.KylesFiero.tk

IP: Logged

RWF
Member

Posts: 366
From: Brevard, NC. USA
Registered: Apr 2002

Feedback score: N/A
Leave feedback

Rate this member

Report this Post01-19-2004 11:36 PM

Just finished this myself...$175 for crank and bearings from Advanced Auto, I did some other PM while it was apart, rear main seal, water pump, oil pump, timing set, clutch and all the assorted gaskets totaled around $550....

IP: Logged

All times are ET (US)


T H I S I S A N A R C H I V E D T O P I C

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock