I broke the vacuum hoses that go the the EGR solenoid. I've no intention of installing the solenoid again, so what is the proper way to make the code stop?

I heard you jump pins B and C. (I assume these are the middle 2) Is this correct?

------------------

I can picture in my mind a world without war, a world without hate.
And I can picture us attacking that world, because they'd never expect it.
01011001011011110111010100100000011000010111001001100101
01100100011101010110110101100010

I did not jump the pins on the connector. The easy way is ----- you have two small black wires pluged into the Solenoid right above the two vacuum lines these have spade terminals and will pull out. they go to the vacuum switch, when there is vacuum these two wires make up and make the ECM think it is getting vacuum. so pull these wires out and connect them together and that is it . no more code 32.
Don

Cool, thanks.

You've probably already nailed it down by now, but...
https://www.fiero.nl/forum/Forum2/HTML/036931.html

I posted pictures (closer to the bottom of the message) for those who need those extra 1000 words.