Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Headlight Motor limit switch

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


Headlight Motor limit switch by FriscoFiero
Started on: 08-05-2003 02:40 AM
Replies: 1
Last post by: GTDude on 08-05-2003 03:47 AM
FriscoFiero
Member
Posts: 31
From: Frisco, TX, USA
Registered: May 2003


Feedback score: N/A
Leave feedback

Rate this member

Report this Post08-05-2003 02:40 AM Click Here to See the Profile for FriscoFieroClick Here to Email FriscoFieroSend a Private Message to FriscoFieroDirect Link to This Post
With the engine off, my left headlight motor is hot and it clicks, trying to turn. This of course means a constant current drain. Can anybody tell me how to adjust the limit switch so that it stays turned off? (86 GT)

Thanks

------------------
Steve

IP: Logged
PFF
System Bot
GTDude
Member
Posts: 9056
From: Keysville, Virginia, USA
Registered: Nov 2001


Feedback score: N/A
Leave feedback





Total ratings: 287
Rate this member

Report this Post08-05-2003 03:47 AM Click Here to See the Profile for GTDudeClick Here to Email GTDudeDirect Link to This Post
Sure, remove the motor and disassemble it. Reassemble it up or down (the armature)so that it will cause the limit switch to engage.

Phil

------------------
87 FIERO GT 2.8 5spd
0-60 in 6.8 seconds!
87 FIERO CPE 2.5 5spd
86 FIERO SE 2.5 AUTO
87 FIERO GT 2.8 4SPD
84 FIERO SE 2.5 4SPD
If you found my advice helpful, please take the time to give me a positive rating. Thanks

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock