Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  What size threads on a stock manual shifter?

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
What size threads on a stock manual shifter? by IRSCISA
Started on: 02-18-2003 08:10 PM
Replies: 2
Last post by: IRSCISA on 02-18-2003 09:17 PM
IRSCISA
Member
Posts: 150
From: CANONSBURG, PA, USA
Registered: Sep 2002

Feedback score: N/A
Leave feedback

Rate this member
Report this Post02-18-2003 08:10 PM Click Here to See the Profile for IRSCISASend a Private Message to IRSCISADirect Link to This Post
I am going to shorten my manual shifter. What size die doe I need to rethread the shortened shifter so that it will take a stock knob? Thanks in advance.
IP: Logged
PFF
System Bot
Jake_Dragon
Member
Posts: 32853
From: USA
Registered: Jan 2001

Feedback score: (5)
Leave feedback





Total ratings: 403
Rate this member
Report this Post02-18-2003 09:05 PM Click Here to See the Profile for Jake_DragonSend a Private Message to Jake_DragonDirect Link to This Post
M16x1.5
IP: Logged
IRSCISA
Member
Posts: 150
From: CANONSBURG, PA, USA
Registered: Sep 2002

Feedback score: N/A
Leave feedback

Rate this member
Report this Post02-18-2003 09:17 PM Click Here to See the Profile for IRSCISASend a Private Message to IRSCISADirect Link to This Post
I couldn't have imagined that this question would have been asked before. My bad!

Thanks for the info.

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock