Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Tie rod thread size question/idea

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Tie rod thread size question/idea by VISCERAL
Started on: 09-12-2001 09:58 PM
Replies: 1
Last post by: cadaver on 09-13-2001 10:53 PM
VISCERAL
Member
Posts: 638
From: Chicago, IL
Registered: Apr 99

Feedback score: N/A
Leave feedback

Rate this member
Report this Post09-12-2001 09:58 PM Click Here to See the Profile for VISCERALSend a Private Message to VISCERALDirect Link to This Post
I was wondering how these bumpsteer tie rods from Baer would work on all four corners of our cars? Take a look. They are most likely for mustangs and camaro's and vettes, but hey, if they fit why not.
http://www.baer.com/options/STEERING.SHTM

could fix the goofy bumpsteer in the rear suspension. Any ideas?

IP: Logged
PFF
System Bot
cadaver
Member
Posts: 1196
From: CA
Registered: Aug 2000

Feedback score: N/A
Leave feedback

Rate this member
Report this Post09-13-2001 10:53 PM Click Here to See the Profile for cadaverSend a Private Message to cadaverDirect Link to This Post
How about asking them as they will need to send the proper length as well so they should know the size needed.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock