 
     |
| Audi A8 My Fiero (Page 210/220) |
|
engine man
|
OCT 21, 11:05 PM
|
|
yes i need to figure out what the belt as i do not see any numbers on it
|
|
|
|
engine man
|
OCT 22, 07:15 PM
|
|
|
well today i canceled the labjack order as i felt it just was not going to be any cheaper and it was going to be more work as i would need to learn how to write code so i ordered the YourDyno controller and software so the dyno should be up and working in about 2 weeks
|
|
|
|
engine man
|
OCT 23, 06:41 PM
|
|
|
Since i bought the dyno i have been feeling like a little kid as i can't wait to get the fiero up on my new toy to tune it
|
|
|
|
engine man
|
OCT 29, 07:16 PM
|
|
|
i have not worked on the car for some time now but i have almost everything to get the dyno up and going i am just waiting on a computer that will be for the dyno only and that should be in tomorrow then i just need to get the rest of the camper off the trailer frame so can mount the dyno on it and do the wiring then i will test it with my truck first then put the fiero up on to see what she has after i do some tuning on it
|
|
|
|
engine man
|
NOV 01, 06:50 PM
|
|
|
the dyno is ready to use other than it needs to be mounted on the ground or like i am doing on a trailer so it is mobile
|
|
|
|
engine man
|
NOV 10, 02:42 PM
|
|
|
today i got after it on striping the camper body off the trailer it is now off and just the floor is left but i think that will rip right off with the truck in 4 wheel low and a strap hooked on and just rip away it will be dyno ready soon
|
|
|
|
engine man
|
NOV 27, 08:27 PM
|
|
|
Happy Thanksgiving everyone as there is so much to be thankful for i just hope you all had as good or better a year than i did and i had a great year and expect another great year and i hope you have a great year
|
|
|
|
engine man
|
DEC 06, 06:42 AM
|
|
|
Wow I just looked back through my thread from the start to where we are right now and i have to thank everyone for the help of pointing me and pushing me in the right direction even those who i did not agree with helped me move forward and rethink so thank you all and sorry if i seemed grumpy to your ideas as i know everyone in the Fiero community wants everyone to succeed so thanks again for the help and support [This message has been edited by engine man (edited 12-06-2019).]
|
|
|
|
engine man
|
JAN 03, 11:05 PM
|
|
ok today i din't work on the car but did see if my boring bar that i bought back a year or so worked so i mounted it up on a block that is cracked to see if it was going to work and it did for about a half inch then the gear that was thought to be bad ended the boring so now i need to disassemble it and repair that and then it will bore nicely as the half inch it did bore looked good.
|
|
|
|
shemdogg
|
JAN 05, 09:09 PM
|
|
That looks like a fun toy! How goes the dyno project?
Happy new year
shem
|
|
|
