|
Hi! I'm a nice guy from Russia, and here is my Plazma! (Page 35/39) |
|
Daniel H
|
OCT 30, 05:13 PM
|
|
. [This message has been edited by Daniel H (edited 10-30-2017).]
|
|
|
Daniel H
|
OCT 30, 05:19 PM
|
|
|
|
Daniel H
|
OCT 30, 05:59 PM
|
|
When all base panels were done, I start to make elements of doors.
I spend a lot of time thinking about armrest design and door handle. Was think about to use some other handle, but decided to not increase complications, and invented design of pad, that will cover stock handle. Armrest design was very complicated thing, by the reason of it must be joint with front panel, be comfortable, and be available to covered with some material. And at all it must be beautiful and compatible with interior and exterior design.
Elements was made from hard foam sheets glued to aluminum base.
Began with armrest.
Next upper panel.
And then door handle pad.
Also made of cardboard paper test panel for door lock and mirror switch.
When all pads where done, I started to cut and grinding them.
Note, at these pictures armrest cut is not finished. So, final form of design will be at next post.[This message has been edited by Daniel H (edited 10-30-2017).]
|
|
|
Sage
|
OCT 30, 07:01 PM
|
|
|
|
Daniel H
|
NOV 08, 04:19 PM
|
|
Next photos.
Made from stainless steel reinforcement element for door closing handle.
After long time mind search for armrest design, found good idea.
Sanding and grinding surfaces to made right fit and prepare to fiberglass lamination:
|
|
|
RCR
|
JAN 12, 06:05 PM
|
|
|
|
ttt123
|
MAR 03, 12:50 PM
|
|
very cool
|
|
|
Daniel H
|
MAR 04, 06:34 PM
|
|
|
|
IMSA GT
|
MAR 04, 08:32 PM
|
|
|
|
sourmash
|
MAR 04, 09:36 PM
|
|
Thanks for the video. Been wondering about the car.
|
|
|
|